MF - 220
MF - 220 mono power amplifier technical characteristics: |
It adopts many years had invented Beone pride of technology, it is the peak supersymmetric lines. Supersymmetric lines by completely symmetrical and reverse phase in part, to enlarge the special crossing cross connection, make rectification of two parts distortion and noisy sound output cancel each other out, in full common-mode rejection rate than negative 60dB and distortion rate of only one percent of general amplifier. Because the two supersymmetric flat amplifier amplification lines from parts to the group is precisely matching line layout and distortion, therefore lower by 20 db, On this foundation, the input level supersymmetric lines using special cross behind the two groups amplifier circuit connected supplement, further make two groups of input amplifier noise and distortion, which followed the same line of large on the noise can be smoothly and distortion, the output is except the signal noise and distortion can further reduce 20 db. And the balance of single amplifiers, connecting supersymmetric balance amplifier can be further reduced distortion and noisy sound with many 100. Now, the structure and the ocl circuit Beone production has been used before all the X series. Level amplifier,
Output Power (8Ω) : Classe AB : 1 x 200 w
Frequency response : 10 Hz - 50kHz
Distorsion : < 0,1%
S/N Ratio : > 120dB
Channel separation : > 110dB
Input level : 1,2 v
Input impédance : 20kΩ
2 Input : 1 balanced - 1 unbalanced
Dimension (L x D x H) : 44 cm x 45 cm x 16 cm
Weight : 20 kg